In nearly all cases, most people spend quite a bit of money buying their lift truck. Therefore, it is really important to take good care of it in order to protect your investment well into the long run. It is really a good idea to know the procedures which are carried out during the maintenance and care of this piece of equipment.
By starting up the forklift and listening closely how it runs is one of the best ways to tell how good the engine is working. For example, if there are any misses or knocks, the equipment is defective and this must raise some issues. Also listen closely for any squealing sounds that come from the belts because these noises would provide you with a wealth of information.
Some of the main parts needing attention during maintenance include the safety warning devices, gauges, horn, the lights and the overhead guard. Any burnt out light bulbs or faulty parts must be replaced as soon as they are noticed. It is also imperative to inspect the wiring.
The battery compartment terminals must be cleaned after the above components have been inspected thoroughly. If the terminals are not clean, be sure to clean them properly. Each cell of the battery should be inspected in order to make certain that the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machinery and after that change the filters. The fuel filters, hydraulic filter and the transmission filter should be replaced regularly. Prior to fitting them, be sure to write the date on the new filters by utilizing a permanent marker to be able to keep track.
After the oil change is finished and the filters have been replaced, a visual inspection of the drive axle has to be performed. If there is a grease fitting on the axle make sure to apply some grease. Inspect the belts on the engine for any frays or cracks. If you find any, fix the problem accordingly. After that, inspect each and every other part of the machine like the wheels. If any type of problem or fault is detected, be certain to address it immediately in order to make certain the machine is working at its safest and optimum levels.